2016年01月13日
Filling G19 Markings
Quick rundown of how I filled in my trades, because I'm bored and I LOVE this new G19. Step one was a quick visit to the Daiso for some very simple supplies: Alcohol wet wipes, white nail polish and non-acetone nail polish remover wipes. Total cost about 300yen.
Next step, disassemble the slide so it's easier to work with and wipe it down with an alcohol wipe to clean any dirt and oil. Dry it, and then apply nail polish over the trades, make sure it's enough to fill the trades.
Next, breakout a nail remover wipe, and carefully swipe up and down across the trades (side to side causes streaking between letters). Keep changing locations on the wipe as it starts to absorb more polish. Once you're satisfied leave it to dry, or use a hair dryer to speed up the process.
After that reassemble and enjoy the kickass new look! Also did the same with the mag round counter markings. Didn't do the circles under, since they're supposed to show how many rounds you have left, but I might do them later with a bronze paint or something.
